====== Getting started ======

To run the program, just do <code>ioscopy</code>

This assume that ioscopy is in your PATH.

A sample circuit is provided for demonstration purposes.


<code>
$ ioscopy
</code>
Just do "File>Run Netlister and simulate..." and fill in the window with the commands provided below:
<code>
For netlister: gnetlist -g spice-sdb -s -o demo.net demo.sch
For simulator: gnucap -b demo.net
Directory: demo/
</code>
then in the terminal window:
<code>
oscopy> oexec demo/demo.oscopy
</code>


===== Running oscopy from gschem =====
To use gschem integration, add the following line to your gschemrc:
<code>(load-from-path "oscopy.scm")</code>

On the next start of gschem, you should see the oscopy menu.
Note that you should have done ''./configure --prefix="same prefix as gschem"''
Then assuming you are in the oscopy directory:
  * launch gschem
  * open demo/demo.sch
  * <code>oscopy>>Launch oscopy</code>
  * Follow the instruction in "Using the GUI". 
  * Once the script finished to execute, go back to gschem and change the value of a component e.g. the capacitor C.
  * <code>oscopy>>Update oscopy</code>
  * once netlister and simulator ran, figures should have changed, e.g. figure 3 vout should have moved and vo not.